Brixwell No-Drill Fixed Panel Glass Clamp Brass, 1/4" Glazing Thickness, Wall Mount, Brushed Nickel Finish

The Brixwell no drill fixed panel glass clamp is designed for securing stationary glass panels without drilling holes or notching the glass. The clamp is made from brass and finished in brushed nickel for compatibility with common bathroom and interior glass hardware. It uses a wall mount installation method and is intended for fixed glass panels only. It measures 1-9/16" in length and 3/4" in width and 13/16" outer depth height, allowing compact placement along glass edges while maintaining proper contact with the panel surface. The clamp supports glass thickness of 1/4" and does not require any glass fabrication, making it suitable for replacement or retrofit applications. The clamp installs using mounting screws supplied for wall, ceiling, or floor attachment. Clear gaskets are included to create a cushioning layer between the clamp and the glass surface. Two nylon tipped set screws are tightened to hold the glass firmly in position after placement. Silicone must be applied along the entire edge of the glass where clamps are used to reinforce the installation. Important installation guidelines must be followed. These clamps must not be used to hinge a door from a fixed panel. Fixed panels must be supported on a minimum of three sides, including top, bottom, and at least one vertical side. Structural backing support is required, and it is the responsibility of the installer to confirm that adequate support is present before installation. This clamp provides an alternative solution where drilled hole glass clamps are not suitable. Care: Wipe dry after use. Clean weekly with mild soap and warm water using a soft cloth. Do not use abrasive cleaners or scrubbing tools.